Pin End 1/4″ wide 4-Packs
ScrollSanders

$8.11

Available in 3 different grits. Read recommendations below to make the best selection for your scroll saw.

Order by part nos.: SC91218BL – 180 grit, SC91222BL – 220 grit, and SC91262BL – Assorted: 180, 220 & (2) 120 grits )

 

Clear selection
SKU: SC91212BL - SC91218BL - SC91222BL - SC91262BL Category:

Description

Recommendations to make the best selection for your scroll saw:
Fits most 5″ scroll saws (Craftsman®, Delta®, DeWalt®, Excalibur®, Ryobi®), but modifications may be required to throat insert or table opening depending upon width of sander used. Be sure to check your table/ throat plate opening before purchasing sanders.
DeWalt® & Excalibur® Scroll Saws only accept the 1/4″ sanders unless you drill the table hole larger.
Dremel® 1670, 1671 & 1680: use pin end sanders. Remove nub of plastic at gate to fit into clamp, if necessary.
Delta®: use side mount, cut table insert to fit sander, or remove table insert.
Ryobi® SC 160: use pin end sanders.
Ryobi® SC 162, 162VS & 165: use plain end sanders only.
Hegner®: use pin end sanders.
Does not fit RBI®, Reliant®, or Moto-Shop®.
Plain end sanders fit most conversion kits for mounting blades with plain ends on pin end saws. More information on ScrollSanders

Order by part nos.: SC91218BL – 180 grit, SC91222BL – 220 grit, and SC91262BL – Assorted: 180, 220 & (2) 120 grits )

Additional information

taxable

t

condition

New

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.